Performance Ignition Wins GRM Ignition
Shootout: Click HERE for
full story
NEW 4101E
-
Performance Advance Curve
-
New Mag trigger
-
New Bosch Blue Coil
-
Fits all 1300, 1600, 1750, and 2
liters (incl. L-Jet )
-
Easy Install
The Aftermarket Electronic
Ignition System Available For Alfa Romeo!
-
NEED to repair your faulty Bosch/Motronic system?
-
WANT a maintenance-free replacement for the outdated points ignition
system?
-
WANT more performance than the stock or any other aftermarket system?
ARPI 4101
For street and modified street
cars. The perfect replacement for the outdated or failed Motronic
ignition. Allows adjustable timing on 1982-89 Spiders. System
can also be used to increase performance on SPICA and carbureted engines.
Easy to install. Instructions included.
(Click HERE for wiring
instructions)
System Includes:
-
ARPI 401 Distributor
with optical trigger
-
PI 3000 Optically triggered
ignition module
-
PI 20 Performance coil (black)
|
 |
 |
$459.00
|
ARPI 4101 R
BRAND NEW TECHNOLOGY!
Developed for racing and modified street cars. This system uses a
12-volt square wave signal allowing it to trigger a multi-strike inductive
module without the use of another box. Easy to install. Instructions
included.
System includes:
-
ARPI 401 Distributor with optical trigger
-
PI 6S Optically triggered multi-strike
ignition module
-
PI 91 Inductive race coil
Magnecor 8.5 mm red competition
wires
|
 |
 |
$595.00
|
System Component Information
Electronic Distributors
-
Both the 4101 and the 4101R share the same
performance-oriented technical characteristics
-
Modified
Bosch-type distributor utilizes precise infrared light triggering
(Click thumbnail for detailed photo)
-
Eliminates wear and tear
of contact points and rubbing blocks
-
Easier tune-ups, just change
spark plugs, cap and rotor
-
Delivers maximum performance
from 4-cylinder Alfa engines
|
Ignition Modules
-
PI 3000 - Included
with ARPI 4101
-
The PI 3000's performance
advantage is due primarily to its use of an ASIC chip. This chip
monitors ignition requirements and controls dwell time and coil current.
The chip is programmed to increase coil current charging time (dwell),
increasing upper RPM spark energy and performance. At low RPM the
chip increases the coil current limit and maximizes spark duration for
quicker starting and more responsive off-idle performance!
-
Delivers up to 150% greater
spark gap energy than stock points systems
-
Can use high output coils
without requiring a ballast resistor
|
-
PI 6S - Included with
ARPI 4101R
-
Multi-strike technology,
built in sequential rev limiter
-
LED provides quick diagnostic
check for presence of trigger signal
-
No need for adjustments,
infrared beam is not affected by oil, dust, or moisture
-
Triggered by a 12-volt optical
trigger in a performance distributor
-
Eliminates the need for another
box to intercept signal
-
Timing retard capability
for turbo of nitrous applications (optional)
|
Ignition Coils
-
PI 20 Oil filled coil,
provides 20 to 50% higher energy than typical stock coils
-
PI 91 Provides up
to 70% greater spark energy than stock coils with outstanding reliability
Coil Specifications
|
PI 20 |
PI 91 |
| Primary Resistance |
1.4 ohms |
43 ohms |
| Secondary Resistance |
5.2 kilohms |
3.0 kilohms |
| Primary Inductance |
7.5 mH |
5.5 mH |
| Secondary Inductance |
26H |
16H |
| Leakage Inductance |
1.3 mH |
0.32 mH |
| Turns Ratio |
60:1 |
54:1 |
| Finish |
Gloss Black |
|
Replacement Points-type
Distributor
401P
Replace your worn distributor and
gain some RML power. Maintains the stock look of points ignition. Performance
advance curve is compatible with all 1956-81 four-cylinder Alfa engines.
Complete with cap and rotor; requires Bosch or Marelli clamp.
$289.00


Magnecor Ignition Cables
-
We are an authorized dealer for Magnecor products and
stock the full line for all cars
-
KV85 Version 5 - Competition cables conduct maximum output
to spark plug, provides full suppression for both EMI and RFI
-
Provides maximum output for specific and conventional
race ignition systems on engines using turbo-charging, super-charging and
exotic fuels
-
Insulating jacket withstands heat up to 1000 degrees F
(540 C) - made from a one compound silicone rubber, lets heat dissipate
away from areas of extreme heat
-
Reduces heat related breakdowns
Check out our very own
Miss
PI!
Please call for further information
or to order your Performance Ignition today! - (386) 258-0243, or print,
fill out and fax our order form!